The end caps are made of soft rubber and serve as protection from sharp ends of the carbon or fiberglass rods.
from 0,10 €*
 
These end caps are injeption molded rubber and have a thicker wall than the standard end caps. Perfect for securing rods / tubes at high stress points, e.g. keel tubes.
from 0,15 €*
 
The thick and wide rubber foot of this caps that is ideal for rods, which should be secured with Velcro. The pressure is distributed and prevents the poking of the Velcro.
from 0,80 €*
Exel
Split nocks are attached to the end of a rod, so you can mount a bridle or rubber to the end of the rod.
from 0,55 €*
 
Split nocks are attached to the end of a rod, so you can mount a bridle or rubber to the end of the rod.
from 0,35 €*
 
These split nocks of HQ have a clamp, which you can use to tighten the sail at the end of a rod.
from 0,35 €*
 
Special conical split cap for HQ Mojo. Robust plastic with holes for bridle and suspension.
1,50 €*
 
Functional split nock from Elliot. It is used to attach the sail to ends of rods or tubes.
from 0,40 €*
 
Functional split nock. It is used to attach the sail to ends of rods or tubes.
from 0,40 €*
Wolkenstürmer
Split nocks are attached to the end of a rod, so you can mount a bridle or rubber to the end of the rod.
0,40 €*
 
Original endcaps for all vertical struts of Rev-Kites and the leading edge from the EXP 1.5. Fits for 1/4" and 5/16" tubes.
15,90 €*
 
Original endcaps for all vertical struts of Rev-RX-Kites and the leading edge from the RX. Fits only for 5/16" tubes.
15,90 €*