End cap, injection molded, thick wall

Material

Rubber

Tube-/Rod Diameter

2 to 6mm

Manufacturer and contact information for this product:

Invento Products & Services GmbH
Klein Feldhus 1
26180 Rastede
T: +49 (0)4402 9262-0
F: +49 (0)4402 9262-29
E-Mail: service@invento-hq.com

Safety instructions for this product:

- Choking hazard due to small parts, keep away from small children
- Danger of strangulation
- Keep away from small children
- Usage only under adult supervision

General safety instructions for kites:

- Attention, danger to life! Never fly a kite during a thunderstorm or if bad weather is coming up.
- Attention, danger to life! Never fly near power lines, busy roads or airports.
- Never fly your kite on crowded flying sites! Ensure that the kite has as much space as required to the left and right as it needs forward.
  Onlookers are often not aware of the risk and are safest if they stay behind the pilot.
- Maintain distance from the other kite fliers. Tight lines cut through each other and are razor-sharp!