For repair or DIY.
The original rods of the Revolution 1.5 EXP. Lightweight, carbon fiber wrapped. Vertical strut or leading edge.
The leading edge consists of three tubes, the middle tube is equipped with inner sleeves at the ends of carbon fiber-solid material to connect the outer leading edge rods.
The vertical spreaders are without connectors. For a complete replacement rod set you will need 4x rod without connector and 1x rod with connector.
- Diameter
- 1/4 inch
- Carbon layers
- 3 Wrap
- Material
- Carbon, wounded
Manufacturer:
Revolution Kites
12170 Dearborn Place Poway, CA 92064
USA
+1 (858) 679-5785
lollyh@rev-usa.com
EU responsible importeur and contact:
Elliot GmbH
Bruchweg 12 a
46509 Xanten
Tel.: +49 28 01 – 984400
Fax: +49 28 01 – 9844020
info@elliot.de
Safety instructions for this product:
- Choking hazard due to small parts, keep away from small children
- Danger of strangulation
- Keep away from small children
- Usage only under adult supervision
General safety instructions for kites:
- Attention, danger to life! Never fly a kite during a thunderstorm or if bad weather is coming up.
- Attention, danger to life! Never fly near power lines, busy roads or airports.
- Never fly your kite on crowded flying sites! Ensure that the kite has as much space as required to the left and right as it needs forward.
Onlookers are often not aware of the risk and are safest if they stay behind the pilot.
- Maintain distance from the other kite fliers. Tight lines cut through each other and are razor-sharp!
Customers who bought this product also bought
Customers who bought this item also bought one of the following products.
.jpg.webp)
.jpg.webp)